Hello,
I've tried following the videos and also trying to design something myself, but I keep getting issues due to the Z axis. I'm attaching a file that is a 3/4" square tube with a series of holes drilled on the both sides. When I go to analyze, it keeps saying to decrease the part thickness to at most 0.125". Could someone take a look at my file and figure out what I'm doing wrong? I have drawn the cross section (two squares) on the top view and set both lines to be stock material wall. Z on outside is 24", and inside Z is air inside.
I have 17 different pieces similar to the one attached, with the Z axis ranging from 4" to 24" and the size being 1/2", 3/4", or 1". Example would be mcmaster part 6582K41. I don't want to put the rest in until I can get the first one working.
Any help will be apprecited.
I didn't find the right solution from the Internet.
References:
https://www.emachineshop.com/forum/viewtopic.php?t=1889
IT asset management software video
Thank you.