Custom made ITE instruments require daily maintenance Tinnitus 911 Review to prevent damage and repair. Due to the close placement of the loud speaker receiver to wax and moisture from the ear canal, there is a greater likelihood of wax and moisture buildup causing hearing aid dysfunction. If your aid appears to be weak, distorted, or dead, a simple cleaning and dehumidifying may fix the problem.Special care must be taken when maintaining your ITE. Never use unapproved liquids, such as water, to clean your ITE. Some alcohol based liquid cleaners are available for purchase to clean hearing aids, but talk with your audiologist before using one. Irreversible damage could occur.Cleaning tools were probably included with your hearing aid. If not, ask your provider where you can get them. To clean your ITE properly, you will need a soft cloth, wax pick or loop, a long plastic filament wax tool, and a soft toothbrush.
First, holding the aid down and away from you, take the wax pick or loop usually plastic or wire and gently pick any wax or debris from the sound opening that fits into your ear canal. Pick in a downward motion, careful not to press too deeply. Deep insertion of this tool may dislodge or damage the receiver loudspeaker.Taking the brush, gently brush off any debris from the outer casing. This is especially important around the microphones and sound openings. Microphone placements vary, but are typically small round openings near the battery door. Ask your provider to point out the locations of your microphones. Even a little buildup on your microphones can affect the sound quality.